Aplikimi me Pistoletë i Bojërave Metalike
Udhëzues teknik hap pas hapi për aplikimin e përsosur të bojërave metalike të arit, argjendit dhe sedefit me pistoletë me depozitë të sipërme.
Aplikimi me pistoletë i bojërave metalike mbi profilet e poliuretanit kërkon rregullim të saktë të presionit të ajrit dhe protokoll të vazhdueshëm përzierjeje për të shmangur sedimentimin e pigmenteve.
Pajisjet e Nevojshme dhe Parametrat e Pistoletës
- Inspect and Clean Polyurethane Substrates — Ensure the rigid polyurethane moulding is completely clean, dry, and free of oil or grease. Lightly abrade the factory-primed surface using granulim 180-220 sandpaper to ensure proper paint mechanical keying.
- Execute Joint Cutting and Mounting — Cut moulding ends at precise 45-degree miter angles. Apply polyurethane assembly adhesive to the joint surfaces and backboard; never use silicone. Fasten the profiles mechanically using screws to ensure structural stabilization.
- Seal Fasteners and Apply Secondary Primer — Fill screw heads and miter joint seams with polyurethane-compatible putty. Sand the filled areas smooth with granulim 180-220 sandpaper once cured. Apply an optional acrylic or polyurethane primer coat over exposed filler or bare cut edges.
- Prepare Paint and Spray Equipment — Thoroughly mix the solvent-based metallic paint with a mechanical stirrer to suspend all pigments. Pour the paint into a top-gravity feed spray gun fitted with a nozzle size of no greater than 1.3 mm.
- Calibrate Fluid and Air Settings — Adjust the spray gun controls to restrict fluid flow while maintaining high atomizing air pressure. Test the spray fan pattern on a scrap piece to verify fine atomization without wet paint build-up.
- Apply Thin Primary Metallic Coats — Spray two thin, light coats over the polyurethane moulding from a distance of 15–20 cm, using 50% pass overlaps. Periodically shake or stir the top-gravity cup during spraying to prevent metallic pigment settling.
- Execute the Misting (Dusting) Coat — Immediately after the base coat pass, pull the spray gun back to 30–40 cm distance. Apply a light, fast misting pass with low fluid volume to land orientation-controlled metallic flakes uniformly across the surface.
Protokolli i Përzierjes së Pigmenteve Metalike
Pigmentet e rënda metalike të arit dhe argjendit fundërrojnë shpejt. Boja duhet të tundet mirë para mbushjes dhe depozita duhet të tundet lehtë periodikisht gjatë sprucimit.
Teknika e Sprucimit me Shtresa të Holla dhe Shtresa e Pluhurosur
Aplikohet me prurje të ulët lënde dhe presion të lartë ajri në 2-3 shtresa shumë të holla. Në fund, nga një distancë prej 40 cm, aplikohet një shtresë shumë e lehtë 'pluhurosjeje' (dusting) për të orientuar në mënyrë të njëtrajtshme thekonet metalike mbi astarin bojë bazë akrilike e bardhë njëkomponentëshe.
Lista e Kontrollit para Sprucimit
Pastroni pluhurin me leckë ngjitëse, kontrolloni tharjen e ngjitësit rreth një orë dhe siguroni ventilim të mirë.