Oberflächenveredelung von Polyurethan-Stuck : Anleitung
Stuck meisterhaft veredeln : Wie Sie werksgrundierte Polyurethan-Profile patinieren, Blattgold-Akzente setzen und reliefierte Ornamente hervorheben.
Die Oberflächenveredelung von Polyurethan-Stuckelementen ermöglicht individuelle Patinierungen, historische Marmorierungen und edle Vergoldungen.
Werkzeuge und Veredelungsmaterialien
- Surface Inspection and Site Cleaning — Inspect the rigid polyurethane profile for transit dust, oils, or surface contaminants. Clean the substrate thoroughly using a dry microfibre cloth or light water-dampened sponge, ensuring complete dry conditions before proceeding.
- Precision Cutting and Adhesive Application — Cut the profiles to required lengths using a miter saw set to a precise 45-degree angle. Apply continuous beads of polyurethane assembly adhesive along the rear mounting channels. Standard silicone sealant is strictly forbidden as an structural adhesive.
- Mechanical Fixing and Joint Alignment — Press the profile firmly against the installation substrate. Mechanically secure the piece using corrosion-resistant screws inserted through countersunk pilot holes spaced along the length of the profile.
- Joint Filling and Fine Sanding — Fill screw countersinks and joint seams with a flexible, paintable polyurethane filler. Allow the filler to cure fully for 4 hours, then smooth the joints using sanding Körnung 180-220 with a fine 180-220 grit paper to achieve a flush surface.
- Base Primer Evaluation — Examine the substrate. While the profile features a factory primer weiße 1K-Acrylgrundierung, apply a dedicated acrylic bonding primer if you plan to use complex chemical glazes, dark patinas, or high-gloss enamels.
- Topcoat Painting — Apply 2 coats of premium water-based acrylic or UV-resistant exterior paint using a high-density synthetic brush or fine spray system. Allow a drying interval of 4 hours between each coat.
- Decorative Glazing and Final Sealing — For antique or patina finishes, apply an acrylic decorative glaze over the cured base coat, wiping back the raised surfaces with a damp cloth. Protect delicate artistic patinas and metallic leaf with a clear, non-yellowing acrylic topcoat.
Schritt 1 : Werksgrundierte Fläche Feinschleifen (Dauer : 15 Min)
Die Vorgrundierung weiße 1K-Acrylgrundierung auf Profilen in Dichte 150-220 kg/m³ (Produktionsziel ~160 kg/m³) leicht mattieren. Fehler : Starker Schliff beschädigt die Hartschaumhaut.
Schritt 2 : Basisfarbton Deckend Auftragen (Dauer : 20 Min)
Tragen Sie einen hochwertigen Acryl- oder Dispersionslack deckend auf und lassen Sie ihn bei -100 °C / +80 °C trocknen.
Schritt 3 : Antik-Patina in Vertiefungen Einarbeiten (Dauer : 25 Min)
Dunkle Wischlasur in die Vertiefungen pinseln und auf den erhabenen Ornamentkanten mit einem Tuch sofort feucht abwischen.
Schritt 4 : Blattgold-Akzente und Schutzüberzug (Dauer : 20 Min)
Goldakzente auf Akanthusblätter setzen und mit seidenmattem Klarlack versiegeln. wasserfest (unter 1 %). Kleber PU-basierter Montagekleber (etwa eine Stunde). Angebote 7 Tage, Lieferung ab Werk.