Montage von Fassadenelementen aus Polyurethan : Anleitung
Handwerksanleitung für Fassadenstuck : Kein Silikon, vollflächige PUR-Verklebung, korrosionsfreie Verschraubung und elastische Versiegelung.
Die fachgerechte Montage von Polyurethan-Fassadenprofilen erfordert eine vollflächige Klebung und den strikten Verzicht auf ungeeignete Silikone.
Wichtiger Praxis-Hinweis : Striktes Silikonverbot
- Substrate Cleaning and Dry Surface Preparation — Inspect the wall substrate for stability, removing loose particles, dust, oil, or existing moisture. Ensure the facade surface is dry and level within acceptable construction tolerances before layout marking.
- Precision Layout and 45-Degree Miter Cutting — Measure installation lines precisely. Cut the rigid polyurethane profiles at 45-degree miter angles for corners and corner joints using a fine-toothed mechanical saw to ensure tight fitting connections.
- Continuous PU Adhesive Application — Apply a continuous, uninterrupted line of polyurethane (PU) mounting adhesive along the back bonding tracks of the profile. Do not use silicone adhesive under any circumstances.
- Mechanical Anchor and Cross Screwing — Press the profile firmly against the wall and install mechanical stainless steel screws through the profile into the wall structure. Drive screws at opposing (cross) angles at all joint intersections to lock the miter seams.
- Putty Application and Körnung 180-220 Sanding — Fill all screw head indentations and joint seams with exterior polyurethane joint putty. After complete drying, sand the joint smooth using Körnung 180-220 sandpaper until the surface is seamless.
- System Priming and Double UV Topcoat Application — Apply an optional exterior system primer over sanded areas if desired. Finish the entire installation with at least two coats of elastic, UV-resistant exterior paint to protect against solar radiation and weathering.
Schritt 1 : Untergrundprüfung und Laserachsen (Dauer : 20 Min)
Tragfähigkeit der Putzschicht prüfen und Montageachsen mit Laser für Profile in Längen 2400-2440 mm der Dichte 150-220 kg/m³ (Produktionsziel ~160 kg/m³) anzeichnen. Fehler : Montage auf feuchtem Mauerwerk.
Schritt 2 : Gehrungsschnitt auf 45 Grad (Dauer : 25 Min)
Sägen Sie die Profile mit einer Kappsäge mit feinem Sägeblatt unter Beachtung von 10% Schnittzugabe bei -100 °C / +80 °C.
Schritt 3 : Vollflächiger PUR-Kleberauftrag und Verschraubung (Dauer : 40 Min)
Tragen Sie den PUR-Kleber PU-basierter Montagekleber (Aushärtung in etwa eine Stunde) raupenförmig auf und sichern Sie Stöße mit versenkten Edelstahlschrauben.
Schritt 4 : Fugen Schleifen und UV-Schutzanstrich (Dauer : 40 Min)
Fugen mit Schleifpapier Körnung 180-220 (Korn 180–220) glätten und 2 Schichten UV-Fassadenfarbe auf Grundierung weiße 1K-Acrylgrundierung auftragen. wasserfest (unter 1 %). Angebote gültig 7 Tage, Lieferung ab Werk.