Montaż Sztukaterii Elewacyjnej : Instrukcja Krok po Kroku
Poradnik montażu na elewacji : technika klejenia pasmowego, mocowanie wkrętami nierdzewnymi i wykonywanie spoin dylatacyjnych.
Montaż sztukaterii elewacyjnej z poliuretanu wymaga precyzyjnego trasowania laserowego i zastosowania ciągłych pasm kleju poliuretanowego.
Krok 1 : Przygotowanie Elewacji i Odpylenie Podłoża
- Substrate Cleaning and Dry Surface Preparation — Inspect the wall substrate for stability, removing loose particles, dust, oil, or existing moisture. Ensure the facade surface is dry and level within acceptable construction tolerances before layout marking.
- Precision Layout and 45-Degree Miter Cutting — Measure installation lines precisely. Cut the rigid polyurethane profiles at 45-degree miter angles for corners and corner joints using a fine-toothed mechanical saw to ensure tight fitting connections.
- Continuous PU Adhesive Application — Apply a continuous, uninterrupted line of polyurethane (PU) mounting adhesive along the back bonding tracks of the profile. Do not use silicone adhesive under any circumstances.
- Mechanical Anchor and Cross Screwing — Press the profile firmly against the wall and install mechanical stainless steel screws through the profile into the wall structure. Drive screws at opposing (cross) angles at all joint intersections to lock the miter seams.
- Putty Application and gradacja 180-220 Sanding — Fill all screw head indentations and joint seams with exterior polyurethane joint putty. After complete drying, sand the joint smooth using gradacja 180-220 sandpaper until the surface is seamless.
- System Priming and Double UV Topcoat Application — Apply an optional exterior system primer over sanded areas if desired. Finish the entire installation with at least two coats of elastic, UV-resistant exterior paint to protect against solar radiation and weathering.
Krok 2 : Docinanie Kątowe 45 Stopni w Skrzynce
Dotnij profile piłą ręczną z naddatkiem montażowym 10%, unikając powstawania wyszczerbień na krawędziach rzeźbionych.
Krok 3 : Naniesienie Ciągłego Pasma Kleju i Wkręty Nierdzewne
Zaaplikuj ciągłe pasmo kleju poliuretanowego klej montażowy na bazie PU (wiązanie w około jednej godziny) i zabezpiecz profil wkrętami ze stali nierdzewnej pod -100 °C / +80 °C.
Krok 4 : Szpachlowanie Spoin, Szlifowanie i Malowanie UV
Wypełnij łączenia elastyczną masą akrylową, przeszlifuj papierem gradacja 180-220 i nałóż 2 warstwy farby fasadowej z filtrem UV na podkładzie biały jednoskładnikowy podkład akrylowy. Nienasiąkliwe (poniżej 1 %). Oferty ważne 7 dni, dostawa loco zakład (EXW).