Kwadratowe belki rustykalne z poliuretanu: Dobór i montaż
Przewodnik montażu masywnych belek rustykalnych z poliuretanu: jak wyznaczyć osie, zamocować klocki montażowe i wykończyć końce belek.
Kwadratowe belki rustykalne z poliuretanu imitują potężne, ciosane pnie drzewne, tworząc monumentalny sufit bez obciążania stropu budynku.
Rozróżnienie: Belka Kwadratowa, Profil U i Krokiew
- Substrate Preparation and Axis Marking — Clean and dry the mounting ceiling or wall substrate to remove dust, oil, and loose material. Measure the layout and mark centerlines using a chalk line based on a planned axis spacing of 60 to 100 cm.
- Precision Profile Cutting — Measure the required log lengths and cut the polyurethane profiles using a fine-toothed hand saw or miter saw. Cut corner joints at a precise 45-degree miter angle for clean corner transitions.
- Polyurethane Adhesive Application — Apply continuous beads of polyurethane assembly adhesive along all profile contact edges that meet the ceiling or wall. Do not use silicone adhesives, as they lack sufficient initial tack and paintability.
- Mechanical Fixing with Counter-Screws — Press the polyurethane log firmly onto the marked axis line. Drive corrosion-resistant screws through pre-drilled, countersunk holes in the profile into structural wall plugs or ceiling joists to ensure mandatory mechanical anchoring.
- Installing End Caps and Decorative Corbels — Fit matching polyurethane end caps to open profile ends and mount decorative corbels at wall-ceiling intersections using polyurethane adhesive and mechanical screws driven into the substrate.
- Joint Filling and Surface Sanding — Fill countersunk screw heads and profile butt joints with compatible exterior-grade filler. Allow the filler to cure fully, then sand the joints smooth using gradacja 180-220 sandpaper.
- Paint Application and Wood-Effect Patina — Apply a base coat of acrylic paint, followed by a wiped wood-effect patina glaze. For exterior installations, apply two coats of a UV-resistant topcoat to protect against environmental degradation.
Dobór Przekroju i Planowanie Rozstawu Osiowego
Do pomieszczeń o wysokości powyżej 2,8 m polecane są przekroje 15x15 cm lub 20x20 cm. Belki o standardowej długości 3000 mm rozmierza się na suficie z rozstawem osiowym 80–120 cm, doliczając naddatek na docinki 10%.
Montaż na Klockach Drewnianych i Kleju PUR
W osi montażu przykręca się do sufitu drewniane klocki bazowe co 80 cm. Wnętrze belki z litego poliuretanu o gęstości 150-220 kg/m³ (cel produkcyjny ~160 kg/m³) smaruje się klejem klej montażowy na bazie PU (pełne utwardzenie około jednej godziny), nasuwa na klocki i stabilizuje wkrętami z boku.
Zaślepki Czołowe, Zastrzały i Wykończenie
Widoczne końce belek zamyka się rzeźbionymi zaślepkami czołowymi, a przejścia w ścianę można urozmaicić ozdobnymi zastrzałami (payanda). Po przeszlifowaniu papierem gradacja 180-220 nakłada się lazury na podkład biały jednoskładnikowy podkład akrylowy. Materiał jest w 100% odporny na wodę (poniżej 1 %) i zakres temperatur -100 °C / +80 °C. Oferta 7 dni, dostawa loco zakład (EXW).