Montaža Konzola ispod Balkona i Erkera

Detaljan korak-po-korak vodič za pravilan proračun ritmičkog razmaka i bezbednu montažu dekorativnih konzola ispod balkonskih ploča.

Montaža poliuretanskih konzola ispod balkona i erkera zahteva precizan proračun modularnog razmaka i primenu adekvatnog lepka kako bi se postigao skladan arhitektonski ritam fasade.

Jasna Izjava o Bezbednosti: Dekorativna Uloga

Measure Facade Overhang and Calculate Spacing — Measure the total linear length of the balcony or bay window underside. Mark the outer corner positions first, then divide the remaining center span into equal increments between 60 cm and 80 cm to determine exact corbel centerlines.
Prepare Substrate and Miter Profiles — Clean the wall substrate to eliminate dust, oil, and loose material. If the corbel profiles meet at facade corners, perform exact 45-degree miter cuts on a fine-tooth saw dedicated to rigid polyurethane.
Apply Polyurethane Assembly Adhesive — Extrude continuous beads of heavy-duty polyurethane (PU) assembly adhesive onto all back and top contact surfaces of the corbel. Do not use silicone, as it lacks structural shear performance.
Mount Profile and Drive Mechanical Fasteners — Press the corbel firmly against the marked layout line on the wall substrate. Immediately drive stainless steel screws through pre-drilled countersunk holes into masonry wall anchors to secure the profile mechanically.
Fill Screw Recesses and Substrate Joints — Apply exterior-grade polyurethane putty over all countersunk screw heads and perimeter joint seams where the corbel meets the wall and ceiling surfaces.
Sand Joints and Evaluate Surface Primer — Allow the putty to cure, then sand all patched surfaces smooth using 180 to 220 grit sandpaper. Inspect the factory primer coat and apply an additional acrylic exterior primer if required by local coating standards.
Apply Final UV-Resistant Exterior Paint — Coat the entire installed corbel assembly with two coats of premium UV-resistant exterior paint to protect the polyurethane material from solar radiation and weather exposure.

Potreban Alat za Montažu

Pripremite: laserski daljinomer, bušilicu, pištolj za kartuše, konstrukcijski lepak montažno lepilo na bazi PU, elastični fasadni kit, šmirglu granulacija 180-220 i fasadnu UV boju.

Korak 1: Proračun Razmaka i Simetrije

Ukupna širina balkona deli se na jednaka polja tako da razmak između konzola iznosi između 60 i 90 cm. Prva i poslednja konzola postavljaju se uz same bočne ivice balkona.

Korak 2: Nanošenje Lepka i Fiksiranje

Lepak montažno lepilo na bazi PU se nanosi na gornju i zadnju stranu konzole koja se pritisne u ugao između zida i balkonske ploče. Veće konzole dodatno se osiguravaju kosim nerđajućim tiplom. Vreme sušenja: oko jedan sat.

Korak 3: Zaptivanje Spojeva, Šmirglanje i Bojenje

Spojevi se popunjavaju elastičnim kitom i šmirglaju sa granulacija 180-220. Nanosi se završna fasadna boja preko fabričkog prajmera beli jednokomponentni akrilni prajmer.