Izbor i Montaža Rustičnih Debala od Poliuretana
Tehnički vodič za pravilan izbor dimenzija kvadratnog preseka i sigurnu plafonsku montažu poliuretanskih debala sa izgledom drveta.
Dekorativna poliuretanska debla (kvadratnog preseka sa autentičnom teksturom drveta) unose moćan rustični karakter u prostor, uz drastičnu prednost u masi u odnosu na puno hrastovo drvo.
Jasna Razlika: Deblo naspram Grede i Roga
- Substrate Preparation and Axis Marking — Clean and dry the mounting ceiling or wall substrate to remove dust, oil, and loose material. Measure the layout and mark centerlines using a chalk line based on a planned axis spacing of 60 to 100 cm.
- Precision Profile Cutting — Measure the required log lengths and cut the polyurethane profiles using a fine-toothed hand saw or miter saw. Cut corner joints at a precise 45-degree miter angle for clean corner transitions.
- Polyurethane Adhesive Application — Apply continuous beads of polyurethane assembly adhesive along all profile contact edges that meet the ceiling or wall. Do not use silicone adhesives, as they lack sufficient initial tack and paintability.
- Mechanical Fixing with Counter-Screws — Press the polyurethane log firmly onto the marked axis line. Drive corrosion-resistant screws through pre-drilled, countersunk holes in the profile into structural wall plugs or ceiling joists to ensure mandatory mechanical anchoring.
- Installing End Caps and Decorative Corbels — Fit matching polyurethane end caps to open profile ends and mount decorative corbels at wall-ceiling intersections using polyurethane adhesive and mechanical screws driven into the substrate.
- Joint Filling and Surface Sanding — Fill countersunk screw heads and profile butt joints with compatible exterior-grade filler. Allow the filler to cure fully, then sand the joints smooth using granulacija 180-220 sandpaper.
- Paint Application and Wood-Effect Patina — Apply a base coat of acrylic paint, followed by a wiped wood-effect patina glaze. For exterior installations, apply two coats of a UV-resistant topcoat to protect against environmental degradation.
Jasna Izjava o Bezbednosti: Dekorativna Obloga bez Nosive Uloge
Strogo se naglašava da su debla šuplje dekorativne obloge i NE smeju se koristiti za prihvatanje statičkog tereta tavanice.
Odabir Dimenzija prema Visini Plafona
Za prostore visine do 2,80 m preporučuju se debla preseka 12x12 cm, dok se za visoke prostore (preko 3,50 m) koriste masivna debla 20x20 cm u standardnoj dužini 3000 mm.
Redosled Montaže na Plafon
Drvene paklice se ušrafljuju u plafon na svakih 80-100 cm. Deblo se navlači preko paklica uz nanošenje lepka montažno lepilo na bazi PU i dodatno bočno fiksira šrafovima. Vreme sušenja: oko jedan sat. Na krajevima se postavljaju dekorativni poklopci i konzole.
Kontrolna Lista pre Kupovine
Izmerite dužinu plafona u komadima 3000 mm, predvidite montažni lepak montažno lepilo na bazi PU i proverite rok ponude 7 dana.